4-channel remote control + 2x

All electrical connections should be made with the voltage disconnected and with particular caution. The control unit should be placed in a housing that sufficiently protects the system against moisture and sunlight. Do not place the device in metal housings - this will result in strong shielding and a drastic reduction in range. The electrical connection of the control panel power supply should be made with a two-wire cable with a cross-section of 0.35 mm2, including a 200 mA fuse in series. Do not confuse the polarity of the supply voltage, as this may result in immediate damage to the control unit. The electrical connections of the device controlled by the control unit should be made with copper wires with a cross-section of 0.75 mm2. Pay special attention to careful installation to avoid accidental short circuits and equipment damage.

Briefly press the button on the control unit (the LED will light up), then press the appropriate button on the remote control depending on the selected operating mode.

The control unit can operate in one of 3 operating modes:

• state change (most common use: remote switches),

• bistable (most common use: DC motor control),

• monostable (most common use: impulse triggering of electrical devices, DC motor control, electric lock control).

In the case of remote controls with a flap, the operating mode of the device will be set during the programming procedure after pressing the button on the remote control: upper left (state change), upper right (bistable) or lower left (monostable).

During normal operation of the device, the upper buttons of the remote control are used to switch relays: upper left (relay K1), upper right (relay K3), lower left (relay K4), lower right (relay K2).

Erasing the remote control memory in the control unit takes a long time, about 5 seconds. holding the button on the control unit (the LED will blink about 10 times and then go off).

If the range is unsatisfactory, straighten the coiled antenna and place the receiver as high as possible above the ground and away from large metal objects.

If the battery in the remote control is discharged, it must be replaced. Only use batteries with the parameters provided with the remote control. Do not change the polarity of the batteries in the remote control.

• Four NO/NC outputs,
• Supply voltage 12-24V DC,
• Range up to 100m,
• Quartz stabilization,
• 3 operating modes (mono-stable, bi-stable and state-change),
• Possibility of control using additional remote controls,
• Possibility of using the device as an additional receiver in gate automation.

Claim orders from Stores

You can claim your purchased items within 1 - 4 work days after making an order (if product is in local warehouse).

Please wait for an email notification regarding Your order status update.

Vilnius Store address: Vytenio g. 20, LT-03229 Vilnius, Lietuva

Kaunas Store address: Pramonės pr. 4D, LT-51329, Kaunas, Lietuva

Local delivery in Lithuania

Purchased items are delivered locally through Venipak service. Depending on availability of items, orders are processed within 1-3 work days. Orders made until 1AM are shipped the same day.

Local delivery  (1-4 w.d.) price for items of any size is through through courier service is 4.90€ (incl. VAT), if the amount of the shopping cart exceeds 150€ - delivery is free.

Local delivery price to Venipak parcel terminals (1-3w.d.) is 2.90€ incl. VAT, if the amount of the shopping cart exceeds 50€ - delivery is free.

Local delivery price to Omniva parcel terminals (1-3w.d.) is 3.90€ incl. VAT,if the amount of the shopping cart exceeds 70€ - delivery is free.

Payment on delivery (COD) +2.00€ (incl. VAT).

You can pay for the goods at the time of delivery to the courier in cash or by credit card. Payment to Omniva parcel terminals is only possible by bank card.

A separate delivery fee applies to oversized items, regardless of the amounts and conditions stated above.

International delivery pricing through courier service

International shipping prices depend on geographic location:

Latvia - 5.50€ (incl. VAT)

Estonia - 6.50€ (incl. VAT)

Paid orders of more than 150€ are shipped for free to Latvia and Estonia.

other countries - negiotiated individually.

International delivery pricing to Omniva/Venipak parcel terminals

Latvia - 6.00€ (incl. VAT)

Estonia - 8.50€ (incl. VAT)

Payments:

We accept payments via PayPal for orders over 20€.