Seeedstudio

Sort By:
Show:
Grove, servo splitter, 20cm, 5pcs
A set of five Grove cables to connect e.g. Base Shield v2 to servers, actuators, sensors, or devices with a Grove connector. Each one is 20 cm long and consists..
8.00€
Temporarily Out Of Stock
Grove, ITR9909 reflectance sensor v1.2
Module from the Grove series is based on a reflective sensor ITR9909. It consists of an LED emitting infrared light and a phototransistor of high sensitivity. B..
8.60€
Temporarily Out Of Stock
Grove, air purity sensor MP503 v1.3
Air purity sensor from Grove series. It is used for detecting gases such as carbon monoxide, alcohol, acetone, thinner, formaldehyde, and others. The kit includ..
8.60€
Temporarily Out Of Stock
Grove, LM386 sound sensor
Module from the Grove series, based on the LM386 system and electret microphone. It can be powered with any voltage from 4 V to 12 V. The output is an analog si..
7.10€
Temporarily Out Of Stock
Grove, a module with MOSFET transistor
It allows for turning on and off devices that require power from 5V to 15V with a digital signal. The module is characterized by a significantly higher switchin..
7.40€
Temporarily Out Of Stock
Grove, RPR-220 reflectance sensor v1.2
Module from the Grove series is based on a reflective sensor RPR-220. It consists of an LED emitting infrared light and a phototransistor of high sensitivity. B..
7.10€
Temporarily Out Of Stock
Bluetooth BLE module HM-BT4502, Seeedstudio 11399081
Bluetooth BLE communication module in standard 5.0, based on HM-BT4502 chip. When connected to a microcontroller, it is able to communicate and send data to dev..
5.50€
Temporarily Out Of Stock
Grove, Base Shield for Arduino Nano
Shield for Arduino Nano is a board fully compatible with Seeeduino Nano. It has 8 connectors, so it is possible to connect many devices, sensors, Grove displays..
5.50€
Temporarily Out Of Stock
Grove, a module with a passive buzzer, Seeedstudio 107020109
A module with a passive buzzer that allows you to change the sound tones by adjusting the PWM frequency. The buzzer can be used as an alarm siren, its maximum v..
5.10€
Temporarily Out Of Stock
Grove, Red Wrapper 1x2, 4pcs
Red cover for Grove series modules has dimensions of 50 x 25 x 13 mm, made of ABS material. Compatible with Lego and MakeBlock blocks, which makes it possible t..
3.90€
Temporarily Out Of Stock
Grove, Buzzer, module with active buzzer
Active buzzer module from Grove. It emits a uniform tone after taking a high position. When using PWM, it can generate different sounds and effects. The power v..
3.10€
Temporarily Out Of Stock
Grove, a set of 5 female-female 4-pin, 2mm / 20cm cables without latch
A set of five 4-pin cables Grove, raster 2 mm. They are used to connect Grove sensors with Base Shield Board. The cable length is 20 cm. Version without a latch..
4.20€
Temporarily Out Of Stock
Grove, blue LED
Module with blue LED, fitted with Grove connectors is ideal for working with Arduino. The LED turns on when the signal pin goes into a high state. In addition, ..
3.90€
Temporarily Out Of Stock
Grove, Button, module with a button
The control module from a Grove series. It has a built-in tact-switch system and pull-down resistor. It communicates with the microcontroller through a digital ..
2.80€
Temporarily Out Of Stock
Power cord JST 2-pin 10cm
The 2-vein connecting cable is ended on one side with JST connector, the pitch of 2 mm, on the other, with cables with the removed insulation. The length is abo..
1.00€
Temporarily Out Of Stock
Showing 321 to 335 of 335 (17 Pages)