DFRobot RS232 Shield - Arduino Priedėlis

Gamintojas: Dfrobot
Prekės kodas: DFR-02992
Prieinamumas: Prekių pristatymas 3-5 d.d.
Planuojama gavimo data po užsakymo: 2020-09-28
13.90€
Be mokesčių: 11.49€

Kiekis

This RS232 Shield For Arduino is designed for the Arduino controller and it can easily convert UART to RS232 interface.
 
The RS232 shield integrates DB9 connectors (female) that provide connection to various devices with RS232 interface. Also the RS232 shield headers will facilitate your connections and commissioning. It provides the welding areas to make full use of extra space on it, which is highly convenient for prototyping. It provides a run / program mode switch. When switched OFF, you'll be able to programme the Arduino controller; When switched ON, you can use the shield normally. Gold immersion PCB. Long pins on the back that are compatible with most Arduino controllers such as arduino Uno, arduino mega, Leonardo.
 
As an alternative of RS232, RS485 provides more reliable way to transfer data at a longer distance. We also have a RS484 shield (Arduino) for this scenario. 

RS232 DB9 Pinout Diagram

RS232 DB9 Pin out Diagram

RS-232 Maximum Cable Length

The maximum cable length for RS-232 is 50ft, but in practise depends on baud rate, cable specific capacitance and ambient noise. The table below contains some rules-of-thumb from experiments done by Texas Instruments years ago. 

Compability

SPECIFICATION

  • Voltage: +5V
  • 16 digital IO port (including a I2C interface)
  • 6 analog IO port and power
  • Operation and programming mode switch
  • Transceiver indicating LED
  • DB9 connectors (female), RS232 pins
  • Weldable area
  • Reset switch
  • Module size: 55mm x 53mm